Sewing Box product of Walnut and Ash

Diy woodworking: A rather unique sewing box, and one that’s quite as convenient as unique, is shown within the illustration. the fabric is walnut and ash. The posts are walnut and also the slats and top rail ash. Both are finished in their natural colors. the subsequent is that the stock bill:

• 4 posts, 1-1/2 in. in diameter and 15 in. long, walnut.
• 1 bottom, 3/8 by 16-1/2 by 16-1/2 in., S-2-S, walnut.
• 4 top rails, 3/8 by 1-1/2 by 20 in., S-2-S, ash.
• 4 under rails, 5/8 by 3/4 by 20 in., S-2-S, walnut.
• 72 slats, 1/8 by 5/8 by 6-1/2 in., S-2-S, ash.

In ordering the stock it’ll be informed combine the lengths of pieces having like widths and thicknesses.

If impracticable to secure doweling of the diameter indicated for the verticals, it’s a straightforward bear on take a square piece of stock, lay it off and work it into an eight-sided prism. After this, the arrises may again be planed until it’s 16 and so 32 sides. the remainder is also removed with sandpaper. Or it’s possible that curtain pole stock are going to be available. Saw these posts to length and leave the ends square.

DIY woodworking

Square up the stock for the opposite parts. Work the underside piece to a 16-in. square. The rails don’t seem to be to be squared on the ends but are to be mitered each successivelythe underside is fastened to the posts by metal brackets.

Chisel out recesses within the posts in order that the underside could also be inserted. Insert the corners and use glue and nails to carry them in situ. Place the lower of the 2 top rails, notching out the posts as is critical to bring the inner fringe of these rails in position. Fasten to the posts. Miter and place the highest rails. The slats, it’ll be noted, are fastened to the underside from the outer side and to the lower of the 2 top rails from the inner side. Brass-headed tacks like upholsterers use are required.

In finishing this diy woodworking project, sandpaper all parts and so apply a coat of boiled oil. Allow this to face a half hour around and so wipe the surface clean. After this has dried thoroughly apply a skinny coating of shellac and permit it to harden. Sand the shellac when hard with No. 00 sandpaper so apply several coats of wax, polishing within the usual manner.

Two pairs of castors will add during this diy woodworking project, to the benefit with which the box is also moved about.

Leave a Reply

Your email address will not be published. Required fields are marked *