How to make a Roman Chair
Woodworking free plans tutorial: In making this roman chair, also as other articles of mission furniture, the materials will be ordered from the mill with much of the labor completed.
Order the stock to form this chair as follows:
* 4 posts, 1-7/8 by 1-7/8 by 30 in.
* 2 top rails, 7/8 by 2-3/4 by 20 in.
* 2 bottom rails, 7/8 by 2-1/4 by 20 in.
* 2 rails, 7/8 by 4 by 16 in.
* 2 side rails, 7/8 by 4 by 28 in.
* 1 stretcher, 7/8 by 3 by 30 in.
woodworking free plans
Have of these pieces mill planed on the four sides straight and square, even have them sandpapered on the four sides of every. Plain sawed white[68] or oak finishes nicely and is definitely obtained.
The sizes are specified exact on thickness and width, but the lengths are longer than is required. this is often to permit for cutting and fitting. Begin this woodworking free plans project by squaring one end of every post; measure the length 28 in. then, put them together side by side, square a line across the four, saw, then plane these ends square.
the highest and bottom side rails are treated in a very similar manner, their length being 19-1/8 in. each.
These pieces extend during the posts projecting 5/8 in. beyond the surface. The mortises within the posts must be cut smoothly and of actual size. Wood pins fasten these rails and posts together. the opposite rails have tenons 1/2 by 3 in. shouldered on the 2 edges and one side.
The mortise within the post is placed central. On the ends of the woodworking free plans chair the shouldered side is turned in , while on the front and back they’re clothed .
Miter the ends of those tenons.
These tenons are to be glued and clamped—the ends of the chair being put together first. When this can be dry the perimeters are clamped.
The stretcher should have its ends shouldered on the 2 edges so on make a 2-1/2-in. tenon. Allow the tenons to increase 1-1/8 in. beyond the cross rail and cut mortises in these tenons for the keys.
All projecting tenons, moreover because the tops and bottoms of the posts, should be chamfered about 1/8 in. For the seat, screw cleats to the insides of the rails and place a platform of thin boards so its top surface is 1/2 in. below the highest of the rails.
A cushion may be made, as shown within the photograph, for this woodworking free plans project, by lacing with leather thongs two pieces of Spanish leather move proper length and width. When nearly laced fill with any of the common upholsterer’s fillings.
woodworking free plans For a brown stain, dissolve by boiling in 4 oz. of water, extract of logwood the scale of a walnut. Apply hot and repeat until the specified color is obtained. Stains may be bought ready prepared, however, and are quite satisfactory. Finish by applying several coats of wax.